MILWAUKEE DIAMOND PLUS™ Dry Holesaw 35 mm

- Diamond grit edge drills and holesaws have been specially developed
for professionals that need to drill in extremely hard materials such as
porcelain/gres/quarry tiles, cast iron or fibreglass where it is
increasingly difficult to drill with conventional holesaws. These
holesaws guarantee excellent performance and superior life time even in
the hardest of materials;
- Water starved: These holesaws only require limited water supply unlike
conventional diamond drills that require a continuous flow of water.
Just dip the drill bit or holesaw into water at the start of each hole
to be cut and thereafter every 5 second cut duration;
- Clean holes: Drills clean, precise holes without any perimeter
scratches;
- Lifetime: To ensure long lifetime, we use high grade diamond for fast
cutting and a superior brazed bond matrix to give best durability;
- Durability: Tough alloy body which does not bend or distort easily.
How to use on an angle grinder:
1. Screw the grinder adaptor M14 to the holesaw and tighten firmly with
a spanner. Then apply the spindle lock on the angle grinder and fit the
adaptor directly onto the spindle; tighten firmly with a spanner;
2. If the tile is not fitted to a wall or floor ensure it is secured
firmly with a clamp;
3. Dip the holesaw tips into water;
4. Switch on angle grinder to full speed. Slowly approach the tile with
the holesaw at a 20-30° angle with light pressure to avoid skating on
the tile. Once the holesaw starts to cut into the tile and forms a
groove, gradually raise the holesaw so that it is horizontal with the
tile;
5. Every 5 seconds dip the holesaw in water;
6. Apply light pressure and an oscillating circular motion during
cutting to maximise tool life.